Granulator The chip stacking problem during use may be caused by a variety of reasons. The following are some suggested steps to solve the chip stacking problem of the granulator:
1、 Check and adjust machine settings
Check the vibratory feeder:
Ensure that the speed of level-1, level-2 and level-3 vibrating feeders is adjusted properly so that the particles can slide evenly and continuously along the vibrating trough plate to the blanking port.
If the vibration is insufficient, it may lead to grain accumulation; If the vibration is too strong, the particles may jump or collide, affecting the accuracy of counting.
2、 Cleaning and maintenance
Clean the inlet and outlet:
Regularly clean the feed and discharge ports of the granulator to prevent impurities, soil and other substances from entering and blocking.
When cleaning, you can turn off the power supply, open the door of the granulator, and remove as many medicine particles and impurities as possible.
Check and replace worn parts:
inspect Full automatic granulator If there is wear or damage to the bearing and transmission parts, replace them in time to eliminate the error caused by wear.
Keep all parts of the machine clean and lubricated to reduce failures caused by friction and wear.
3、 Optimize operation process
Pay attention to the matching of vibrating discharge and rotary table speed:
During the operation, the vibrating discharge shall match the speed of the rotary table to ensure that there is no material accumulation on the surface of the plate, so as to avoid blocking the track.
Pay special attention to capsules and other medicine particles that are easy to overlap. If there is too much material falling, the vibration and rotary table speed should be adjusted in time.
Place the medicine bottle correctly:
During bottling, place the medicine bottle at the discharge port of the machine, gently upward until it touches the contact switch, so that the counting disk can rotate.
Ensure that the medicine bottle is placed stably to avoid the accumulation of medicine particles caused by shaking.
4、 Contact Technical Support
Consult the manufacturer's customer service:
If the above steps cannot solve the problem, you can contact the customer service or technical support team of the manufacturer of the granulator.
provide Granulator The customer service personnel can provide more specific solutions by providing information such as the model, fault phenomenon, etc.
The above steps can effectively solve the problem of stacking flakes on the granulator, and improve production efficiency and product quality.
